Euphonix System 5 Uživatelský manuál

System 5 Post and Film Setup GuideDocument Revision: 1.1Release Date: August 2004Euphonix Inc.220 Portage Ave.Palo Alto, California 94306Phone: 650-85

Euphonix System 5 Post and Film Setup Guide10Blank Panel8.2001.8002.3001.8001.150.28511.96011.00X2.480X2.25.43710.9606.700FREE SPACE.500.500.875.625

Euphonix System 5 Post and Film Setup Guide11Record Control SetupVersion 2.5 of eMix added record and track-arming functionality to the System 5 conso

Euphonix System 5 Post and Film Setup Guide12Solo LinkingIn a multi-operator system, one console is designated the Master. In this document, the Mast

Euphonix System 5 Post and Film Setup Guide13Network SettingsAll of the following settings are found in the Network dialog in the Control Panel. Open

Euphonix System 5 Post and Film Setup Guide14Assign IP address to Second Adaptor Card1. Click the Properties tab to display the following dialog box.

Euphonix System 5 Post and Film Setup Guide15Change the Binding Order1. Click the Bindings tab.2. Select all protocols from the show bindings for drop

Euphonix System 5 Post and Film Setup Guide16Configure DCOM using Dcomcnfg1. After restarting the computer, open up a DOS Command prompt and type dco

Euphonix System 5 Post and Film Setup Guide174. Change the Access, Launch, and Configuration permissions by clicking each one’s Edit Default button an

Euphonix System 5 Post and Film Setup Guide186. Click the Application tab and locate the service called S5MultiServer.Figure 6 Applications Tab in Di

Euphonix System 5 Post and Film Setup Guide197. Double-click on S5MultiServer to display the following dialog box. Figure 7 S5Multiserver Properties D

In the interest of continued product development, Euphonix reserves the right to make improvements in this manual and the product it describes at any

Euphonix System 5 Post and Film Setup Guide2010. Click the Location tab.Figure 3: Location Dialog - Run on this computer.11. On the Master console (S

Euphonix System 5 Post and Film Setup Guide21Check Registry Settings1. Open a Command Prompt and type regedit to start the registry editor.Figure 1 Re

Euphonix System 5 Post and Film Setup Guide22Setting up MOConfig1. Open up a Windows Explorer window and locate the C:\emix directory. 2. Double-clic

Euphonix System 5 Post and Film Setup Guide23Bus Cascade InputsThere are MADI port on the front of the last (highest numbered) DF64 that are dedicat-e

Euphonix System 5 Post and Film Setup Guide24Block DiagramFigure 5: Dual Operator System Block DiagramSlave Console Master ConsoleFilmPanelSlaveConso

Euphonix System 5 Post and Film Setup Guide iiiTable of ContentsCM403 Installation ...

Euphonix System 5 Post and Film Setup Guide5CM403 InstallationCM403 ModuleThe CM403 uses the same form factor and architecture as a standard control m

Euphonix System 5 Post and Film Setup Guide6ID selectionUp to four CM403 modules can be installed in a System 5 console. Set the ID switches on the b

Euphonix System 5 Post and Film Setup Guide7Film Panel InstallationNOTE: Each instruction pertains to the picture beneath its text.Connect the 5-V pow

Euphonix System 5 Post and Film Setup Guide8Connect the opposite end of the PC104 cable to the PC104 card on the SBC (Single Board Computer) mounted

Euphonix System 5 Post and Film Setup Guide9Connect the TFT backlight cable to the connector on the upper board of the film panel.Joystick Panel Insta